Electrolux Dishwasher Error Code Er-07 or Er-11

Er-07 or Er-11 signifies a malfunction in the dishwasher’s drain valve. The drain valve plays a crucial role in expelling wastewater from the appliance after each cycle. When this component fails, it can disrupt the normal functioning of the dishwasher.

1. Power Shutdown: Begin by turning off the power to the dishwasher. This ensures safety during the inspection and potential repairs.
2. Inspect Wiring: Carefully examine the wiring connected to the drain valve. Look for any visible signs of damage, such as fraying or exposed wires. Ensure that the connections are secure.
3. Replacement of Drain Valve: If the wiring appears intact, the next step is to replace the drain valve. Over time, these components can wear out or become faulty, leading to errors in the system.

Detailed Steps:

• Turn Off Power: Locate the dishwasher’s power source and switch it off. This is a crucial safety measure before proceeding with any inspection or repairs.
• Access the Drain Valve: Depending on your dishwasher model, you may need to remove the bottom panel or access the valve from the inside. Refer to your user manual for guidance.
• Inspect Wiring: Check the wiring connected to the drain valve. Look for any signs of wear or damage. If issues are detected, replace or repair the affected wiring.
• Replace the Drain Valve: If the wiring is in good condition, proceed with replacing the drain valve. This component is essential for proper drainage after each wash cycle.

Understanding Electrolux dishwasher error codes Er-07 or Er-11 is crucial for maintaining the appliance’s optimal performance. By following these troubleshooting steps, you can identify and address drain valve failures efficiently. Remember to exercise caution by turning off the power before inspecting or replacing any components.

Keep an eye on our blog for more insights into Electrolux dishwasher error codes and practical solutions to keep your appliance running smoothly.