ClickCease
BOOK ONLINE HERE & SAVE 10%
Electrolux Washer Error Code E24

Electrolux Washer Error Code E24

Error Code E24 is a signal from your Electrolux washer that there’s a glitch in the sensing circuit of the drain pump triac. In simpler terms, it points to an issue in the mechanism responsible for draining water during the wash cycle. While this might seem like a complex problem, fear not – our step-by-step guide is here to assist you in resolving it without the need for professional intervention.

DIY Solution: Replacing the Main PCB:

The most effective way to tackle Error Code E24 is to replace the main PCB (Printed Circuit Board). The main PCB acts as the brain of your washing machine, coordinating various functions, including the drain pump. Follow these DIY steps to replace the main PCB:

  1. Safety First: Before starting any repairs, unplug your Electrolux washer to ensure your safety.
  2. Locate the Main PCB: Consult your washer’s manual to identify the location of the main PCB. Typically, it’s situated in the control panel area.
  3. Remove the Old PCB: Carefully disconnect all wires connected to the main PCB. Take note of their positions or snap a quick photo for reference. Unscrew the PCB from its housing.
  4. Install the New PCB: Place the new PCB in the same position as the old one. Secure it in place with the appropriate screws and reconnect all wires according to your reference.
  5. Power Up: Plug your washer back in and power it up. Run a test cycle to ensure the error code is no longer present.

Remember, if you’re unsure or uncomfortable with these DIY steps, it’s always wise to seek professional assistance.